IEI Integration NANO-HM651 - Manual (Page 57)

NANO-HM651 EPIC SBC
Page 43
4.6 Jumper Settings
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three
metal pins and a small metal clip (often
protected by a plastic cover) that slides over
the pins to connect them. To CLOSE/SHORT
a jumper means connecting the pins of the
jumper with the plastic clip and to OPEN a
jumper means removing the plastic clip from a jumper.
Before the NANO-HM651 is installed in the system, the jumpers must be set in
accordance with the desired configuration. The jumpers on the NANO-HM651 are listed in
6
Table 4-1.
Description Label Type
AT/ATX power mode select J_ATXCTL1 3-pin header
Clear CMOS J_CMOS1 3-pin header
LVDS voltage select J_VLVDS1 3-pin header
LVDS panel resolution select J_PID1 8-pin header
TPM setting ME_RTC1 3-pin header
Flash descriptor security override J_FLASH1 3-pin header
Table 4-1: Jumpers
4.6.1 AT/ATX Power Mode Select Jumper
Jumper Label: J_ATXCTL1
Jumper Type: 3-pin header
Jumper Settings: See Table 4-2
Jumper Location: See Figure 4-4