8 internal peripheral device connections, 1 at power connection – IEI Integration NANO-HM651 User Manual

Page 64

NANO-HM651 EPIC SBC

Page 50

4.8 Internal Peripheral Device Connections

This section outlines the installation of peripheral devices to the onboard connectors.

4.8.1 AT Power Connection

Follow the instructions below to connect the NANO-HM651 to an AT power supply.

WARNING:

Disconnect the power supply power cord from its AC power source to

prevent a sudden power surge to the NANO-HM651.

Step 1:

Locate the power cable. The power cable is shown in the packing list in

Chapter 3.

Step 2:

Connect the Power Cable to the Motherboard. Connect the 4-pin (2x2) Molex

type power cable connector to the AT power connector on the motherboard. See

Figure 4-10.