IEI Integration PCIE-G41A2 - Manual (Page 60)

PCIE-G41A2 PICMG 1.3 CPU card
Page 48
Step 3: Insert the cable connectors . Once the cable connectors are properly aligned
with the USB connectors on the PCIE-G41A2, connect the cable connectors to
the on-board connectors. See Figure 4-12.
Figure 4-12: Dual USB Cable Connection
Step 4: Attach the bracket to the chassis. The USB 2.0 connectors are attached to a
bracket. To secure the bracket to the chassis please refer to the installation
instructions that came with the chassis. Step 0:
4.5 External Peripheral Interface Connection
This section describes connecting devices to the external connectors on the PCIE-G41A2.
4.5.1 LAN Connection
There are two external RJ-45 LAN connectors. The RJ-45 connectors enable connection
to an external network. To connect a LAN cable with an RJ-45 connector, please follow
the instructions below.
Step 1: Locate the RJ-45 connectors. The locations of the USB connectors are shown
in Chapter 4.