Extron Electronics SSP 7.1 User Guide - Manual (Page 90)

Error Messages
E01 — Invalid input channel number (too large)
E10 — Invalid command
E13 — Invalid value (too large)
E14 — Not valid for this configuration
NOTE: No Override ( X3* = 0) in the E U command cannot be viewed or configured:
attempting to do so produces an E14 error message
Expected Unsolicited Responses
Some events trigger a response from the SSP 7.1 without an SIS command being entered:
Event Response
Audio Input Aud X!]
Audio Input Source Change SrcFormat X2$ •Sampling X2% •EnChan X2^]
Volume Level Vol X^]
Input Listening Mode SspL X! * X2$ * X1@]
Mode Override Selection SspQ X! * X2$ * X3*]
Analog Level Input Adjustment SspA X(]
Front Panel Lockout Exe X#]
Clip Sts3* X#]
DTS 96/24 if DTS Source Format DTS9624• X#]
SSP 7.1 • SIS Commands 84