Extron Electronics SSP 7.1 User Guide User Manual

Page 86

— Volume Adjustment (0 - 100, default = 50 dB; corresponding to attenuation of -100

to 0 dB in 1 dB steps).
Max volume (no attenuation) = 0 dB; Min volume (full attenuation) = -100 dB

NOTE: The unit response to a command adjusting the volume always has three digits

and, if necessary, includes leading zeros. The command does not have to include
any leading zeros.

Example

Command: 50V (set the volume to 50 dB; no leading 0)
Response: Vol050] (volume set to 50 dB; with leading 0)

— Furthest speaker distance (in units of 0.01 seconds; default = 0)

NOTE: Furthest speaker distance is included for reference only; it is used only with the

SSP 7.1 Setup and Control Software (see

— Input gain and attenuation readout (0 to +24 dB in 1 dB steps; default 0 dB)

X1)

— Mono source

1 = Left

2 = Right

3 = Left + Right (default)

X1@

— Listening Mode (Matrix Decode Mode indicator on the front panel)

1 = Stereo

2 = Mono

3 = Stereo to All

4 = Mono to All

5 = Dolby Pro Logic

6 = Dolby Pro Logic II/IIx Movie

7 = Dolby Pro Logic II/IIx Music

8 = Dolby Digital 5.1

9 = Dolby Digital EX

10 = Dolby Digital Pro Logic IIx Movie

11 = Dolby Digital Pro Logic IIx Music

12 = DTS or DTS 96/24

13 = DTS ES Matrix or DTS 96/24 ES Matrix

14 = DTS ES Discrete

15 = DTS + Dolby EX or DTS 96/24 + Dolby EX

16 = DTS + Dolby Pro Logic IIx Movie or DTS 96/24 + Dolby Pro Logic IIx Movie

17 = DTS + Dolby Pro Logic IIx Music or DTS 96/24 + Dolby Pro Logic IIx Music

18 = DTS Neo:6 Cinema

19 = DTS Neo:6 Music

X1#

— Status

0 = Not present or malfunction

1 = present or OK

X1$

— Internal temperature in °C

X1%

— Speaker delay (default = 0 on all channels)

SSP 7.1 • SIS Commands