Extron Electronics SSP 7.1 User Guide User Manual
Page 14
z
To All (TO ALL) — Distributes a mono or 2-channel source to all applicable
channels.
z
Mono sources are sent to all available output channels, including center.
z
2-channel sources are sent to all stereo pairs only.
z
Multichannel sources are downmixed and output to Mono to All or Stereo to
All, as defined by the user.
z
Digital or analog stereo sources may be output to Mono to All or Stereo to All,
as defined by the user. If Mono to All is selected, the signal is downmixed to
mono before being output to all channels.
NOTE: If an analog mono source is on the left channel, Stereo to All listening
mode outputs only to the left channels of available stereo pairs. A right
channel analog mono source is output only to the right channels of
available stereo pairs.
When used in conjunction with the Input buttons, the Mode Override button is used to
The Mode Override button is used to perform a complete system reset (see
To learn more about listening modes, see
learn how listening modes depend on both source format and speaker configuration,
see
“Source Formats and Listening Modes with Different Speaker Setups”
on
page 75.
SSP 7.1 • Features
8