Vanguard CT-7000 S2 User Manual

Page 47

REV 2 CT-7000 S2 USER’S MANUAL

NOTE

If there is no setup stored in the selected memory location, the following
screen will be displayed:

Press any key to return to the “START-UP” menu.

f. The following screen will be displayed:

Press the

[ENTER]

key to load the selected setup.

g. The following screen will be displayed:

Press any key to return to the “START-UP” menu.

Printing a Resistor Type Transducer Setup Directory

You can print a directory of the stored resistor type transducer setups on the built-in thermal
printer using the steps below:

a. Start from the “START-UP” menu:

Press the

[3]

key (SETUP).

b. The following screen will be displayed:

Press the

[2]

key (MEASUREMENT UNITS).

1. ANALYSIS POINTS

2. MEASUREMENT UNITS

3. SAVE / RESTORE

4. NEXT PAGE

1. TIME BRKR 02/07/11

2. GET RSLT 14:05:06

3. SETUP

4. DIAGNOSTICS

SETUP LOADED!

SETUP NUMBER: 1
NOTE
ENGLISH
“ENTER” TO CONTINUE

SETUP NOT FOUND