Vanguard DMOM-100_200 s2 - Manual (Page 37)

DMOM-100/200 Series 2 Operating Procedures
37
Rev 2, 2009
7.12 Erasing Test Records
This procedure describes the steps to delete a single test record or all the test records stored in the
DMOM’s Flash EEPROM.
Table 11.0 Erase Test Record Procedure
STEP ACTION DMOM DISPLAY
11-1 On the RESTORE RECORD display (step
9-2), press key # 3 (ERASE RECORD) to
display the ERASE RECORD menu of
options (shown at right).
11-2 On the ERASE RECORD menu display,
press key # 1 to erase a single record.
To erase all records, press key # 2, then
continue with step 11-4.
11-3 Enter record number to be deleted then press
the ENTER key to confirm. A screen will
appear noting that RECORD NUMBER: xx
ERASED! (where xx = the record number).
Press the ENTER key again to return to the
main menu.
NOTE
Press the STOP key to abort.
11-4 The ERASE ALL RECORDS menu will
appear. Press the ENTER key to confirm
that you want to erase all records.
NOTE
Press the STOP key to abort.
11-5 The ERASING RECORDS menu will appear
during the erasure process.
11-6 When the records have all been erased, the
RECORDS ERASED screen will be
displayed.
Press the ENTER key to return to the main
menu.
ERASE RECORD
1.ERASE SINGLE RECORD
2. ERASE ALL RECORDS
ERASE RECORD
NUMBER: XX
RECORD NUMBER: XX
ERASED!
ERASE ALL RECORDS!
Are you SURE?
“ENTER” TO CONTINUE
ERASING RECORDS
PLEASE WAIT
RECORDS ERASED!