Vanguard DMOM-100_200 s2 User Manual
Page 25
DMOM-100/200 Series 2 Operating Procedures
25
Rev 2, 2009
Table 5.0 Run Test Procedure (Measure an Unknown Resistance Continued)
ITEM ACTION
DMOM
DISPLAY
5-20
Pressing key # 2 (NO) in response to the
SAVE THIS TEST RECORD menu (see
step 5-17) causes the ARE YOU SURE
prompt (shown at right) to be displayed.
To not save the record, press key # 1. To
save the record, press key # 2.
5-21
If key # 1 is pressed in response to the
ARE YOU SURE menu, the test record
will be erased from the working buffer
and the display will return to the START
MENU. If key # 2 is pressed, the test
record will be saved in Flash EEPROM.
The test record number assigned to this
record will also be displayed (see the
illustration in step 5-18). Pressing the
ENTER key to return to the START
MENU.
This ends the RUN NORMAL TEST procedure.
Figure 15.0 Typical DMOM-100/200 Test Report
1. RUN TEST 12/11/08
2. SETUP 12:24:01
3. CAL CHECK
ARE YOU SURE?
DATA WILL BE LOST!
1. DO NOT SAVE RECORD
2. SAVE RECORD