Vanguard DMOM-100_200 s2 - Manual (Page 20)

DMOM-100/200 Series 2 Operating Procedures
20
Rev 2, 2009
Figure 13.0 The SETUP Menu
The SETUP MENU lists the following 4 user options.
Item 1 (ENTER ID) is used to input identification information for each stored data record.
Item 2 (REVIEW RECORD) is used to review stored records.
Item 3 (RESTORE RECORD) is used to erase or restore test records or to print a directory of test
records in stored memory.
Item 4 (NEXT PAGE) is used to put the DMOM under PC control or to set the time and date.
7.5 Entering Alphanumeric Characters
Entering alphanumeric characters is performed via the keypad (similar to a telephone keypad –
see item 7 of Figure 6.0 and Figure 7.0). To input characters, press the key once to select the
number marked on the key. Press the key a second time to select the first letter marked on the
key. Press the key a third time to select the second letter marked on the key. Press the key a
fourth time to select the third letter marked on the key.
Additional key presses will repeat the selection cycle (e.g., 2, A, B, C, 2 . . .).
When the character of choice is selected, press the
∧ key to advance to next character space;
press the
∨ key to move the cursor back one character space. The ∧ key may also be used to
create a space between words. Press the CLEAR key to delete a selected character (the cursor
must be under the character to be deleted).
Press the ENTER key to load all character selections into memory and move to the next input
screen.
If no information is needed in a particular input screen, press the ENTER key and the display
will advance to the next screen without any data entry.
1. ENTER ID
2. REVIEW RECORD
3. RESTORE RECORD
4. NEXT PAGE