Vanguard DMOM-100_200 s2 - Manual (Page 29)

DMOM-100/200 Series 2 Operating Procedures
29
Rev 2, 2009
7.8 Entering Test Record ID
This procedure allows the user to enter the equipment identification data to the test record.
Table 7.0 Enter Record ID Procedure (Company, Site, and Equipment Identification)
STEP ACTION DMOM DISPLAY
7-1 Press key # 2 on the START MENU to
go to the SETUP MENU shown at right.
Note
Setup options 2 thru 4 go to the following
procedural tables:
2. REVIEW RECORD procedures in Table
8.0
3. RESTORE RECORD Procedures in
Table 9.0
4. NEXT PAGE procedures in Table 12.0.
7-2 On the SETUP MENU, press key # 1
(ENTER ID) to begin entering equipment
ID data begining with the COMPANY
input screen.
Note:
See Section 7.5 for instructions on
entering alphanumeric characters with the
keypad.
7-3 Enter the utility COMPANY name using
the alphanumeric keypad. Press the
ENTER key to load the entered characters
and advance to the STATION input
screen.
7-4 Enter the utility STATION name using
the alphanumeric keypad. Press the
ENTER key to load the entered characters
and advance to the CIRCUIT input
screen.
7-5 Enter the test item’s CIRCUIT name
using the alphanumeric keypad. Press the
ENTER key to load the entered characters
and advance to the MANUFACTURER
input screen.
7-6 Enter the test item’s MANUFACTURER
name using the alphanumeric keypad.
Press the ENTER key to load the entered
characters and advance to the MODEL
input screen.
1. ENTER ID
2. REVIEW RECORD
3. RESTORE RECORD
4. NEXT PAGE
COMPANY:
STATION:
CIRCUIT:
MANUFACTURER:
MODEL: