Installation instructions – Staub Electronics B-500-RX-230-IR BINARY - HD BASE T RECEIVER WITH BI-DIRECTIONAL IR FOR B-500 HDBASET MATRIX SWITCHERS User Manual

Page 8

pg.8

B-500-RX-230-IR Installation Manual

Follow these steps to install the receiver:

1. Turn off all equipment to be connected.

Do not connect power to the B-500-RX-230-IR until all

other connections are made.

2. Run the HDBaseT cable from the location of the Transmitter to the location of the Receiver and

terminate the ends.

3. Test the HDBaseT cable using a continuity tester or network analyzer.

4. Connect the HDBaseT cable to the B-500-RX-230-IR Receiver and the transmitting device

being used.

5. Connect an HDMI cable between the HDMI Out port of the B-500-RX-230-IR and the HDMI input

of the display.

6. Screw the power connector into the latch locking jack on the Receiver, and then plug the power

supply into an AC outlet. The Power LED at the Receiver should illuminate solid RED.

7. Test the system by playing media at the highest resolution that can be supported by all of the

equipment.

8. After testing is complete and the unit is functional, mount the Receiver in the desired location.

LINK

IR IN

ALL IR OUT

B-500-MTRX-230-4x4

B-500-RX-230-IR

HDTV

Power

Cat 5e/6

HDBaseT

HDMI

*Can also be used with other HDBaseT transmitters.

7. Installation Instructions

Important! It is essential to have HDBaseT pass-through working correctly before other features are
configured, so make sure this portion of the install is functional before setting up IR serial pass-through.