Staub Electronics B-500-RX-230-IR BINARY - HD BASE T RECEIVER WITH BI-DIRECTIONAL IR FOR B-500 HDBASET MATRIX SWITCHERS - Manual (Page 10)

pg.10
B-500-RX-230-IR Installation Manual
© 2013 Binary
8.2. IR Installation
IR pass-through can be used in two ways, to control displays from the transmitting location (via
commands from an automation system), or to control sources and the matrix using IR remotes in the
rooms where displays are located. Commands may be passed in both directions at once if necessary.
To install the IR receivers and flashers, plug the devices into the correct ports as indicated and then
locate the best location for placement to either capture commands or control the device.
8.3. IR Pass-Through Application Diagrams
8.3.1. IR Control System to Control Displays
LINK LINK LINK LINK
IR IN
ALL IR OUT
B-500-RX-230-IR
IR Outputs IR Inputs
Control System
PLAY
HDMI Source
3.5mm Mono Cable
HDTV
Flasher Outputs
IR Flasher to
Control Display
IR Input to Room
IR Flasher Port
HDBaseT Cat5e/6
IR Flasher to
Control Source
Note: IR functionality of other transmitters may vary. Refer to the documentation for the transmitter
being used for information on its IR pass-through functionality.
8.3.2. IR Receiver System to Control Sources
LINK LINK LINK LINK
IR IN
ALL IR OUT
B-500-RX-230-IR
PLAY
HDMI
Source
IR Receiver
HDBaseT Cat5e/6
HDTV
Capture Commands at Display
IR Flasher to
Control Source
IR Receiver Port
IR Out to Source
Note: IR functionality of other transmitters may vary. Refer to the documentation for the transmitter
being used for information on its IR pass-through functionality.