LevelOne IES-1085 - Manual (Page 96)

User Manual Page 96
LEVEL Threshold value 0 ~ 131 mA.
4. Example:
The following example sets high transmitter laser bias alarm threshold 131 mA for SFP
transceiver of interface ge1 (port G1):
switch_a(config)#sfp set-tx-bias ge1 high-alarm 131
switch_a(config)#
Tx-pow Alarm (Warning) Threshold:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to set transmitted output power alarm (warning) threshold for SFP
transceiver.
3. Command Syntax:
sfp set-tx-pow IFNAME high-alarm｜high-warning｜low alarm｜low warning LEVEL
IFNAME specifies the name of the interface for which status and configuration
information is desired.
LEVEL Threshold value -30 ~ 8.16 dbm.
4. Example:
The following example sets high transmitted output power alarm threshold 8.16 dbm for
SFP transceiver of interface ge1 (port G1):
switch_a(config)#sfp set-tx-pow ge1 high-alarm 8.16
switch_a(config)#
Rx-pow Alarm (Warning) Threshold:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to set received optical power alarm (warning) threshold for SFP
transceiver.
3. Command Syntax:
sfp set-rx-pow IFNAME high-alarm｜high-warning｜low alarm｜low warning LEVEL
IFNAME specifies the name of the interface for which status and configuration