LevelOne IES-1085 - Manual (Page 86)

User Manual Page 86
WORD specifies the file name to be loaded to switch.
4. Example:
The following example specifies upgrading firmware (file name: flash.tgz) from tftp server
(IP address: 192.168.1.100) to switch:
switch_a#install image 192.168.1.100 flash.tgz
switch_a#
Load config to TFTP server:
1. Command Mode: Privileged Exec mode
Logon to Privileged Exec Mode (Enable Mode).
The switch_a# prompt will show on the screen.
switch_a#
2. Usage:
Use write config-file command to backup configuration file to tftp server.
3. Command Syntax:
write config-file IP-ADDRESS
IP-ADDRESS specifies the IP address of tftp server.
4. Example:
The following example backups configuration file to tftp server (IP address: 192.168.1.20):
switch_a#write config-file 192.168.1.20
switch_a#
Save Configuration:
1. Command Mode: Privileged Exec mode
Logon to Privileged Exec Mode (Enable Mode).
The switch_a# prompt will show on the screen.
switch_a#
2. Usage:
Use copy running-config startup-config command to write configurations to the file to
be used at startup. This is the same as the write memory command.
3. Command Syntax:
copy running-config startup-config
4. Example:
The following example specifies writing configurations to the file to be used at startup to
switch:
switch_a#copy running-config startup-config