LevelOne IES-1085 User Manual
Page 130

User Manual
Page 130
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use wrr-queue cos-map command to specify CoS values for a queue.
3. Command Syntax:
wrr-queue cos-map QUEUE_ID COS_VALUE
QUEUE_ID Queue ID. Range is 0-3.
COS_VALUE CoS values. Up to 8 values (separated by spaces). Range is 0-7.
4. Example:
The following example shows mapping CoS values 0 and 1 to queue 1 on the switch:
switch_a(config)#wrr-queue cos-map 1 0 1
switch_a(config)#
DSCP
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use mls qos map dscp-queue command to map the DSCP values to a queue.
3. Command Syntax:
mls qos map dscp-queue DSCP_VALUE to QUEUE_ID
DSCP_VALUE DSCP values. Up to 8 values (separated by spaces). Range is 0-63.
QUEUE_ID Queue ID. Range is 0-3.
4. Example:
The following example shows mapping DSCP values 0 to 3 to queue 1 on the switch:
switch_a(config)#mls qos map dscp-queue 0 1 2 3 to 1
switch_a(config)#