LevelOne IES-1085 - Manual (Page 106)

User Manual Page 106
(no) poe power-down-alarm enable
4. Example:
The following example shows the use of poe power-down-alarm enable to the interface
fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if )#poe power-down-alarm enable
switch_a(config-if )#
PoE Scheduling
PoE Schedule:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if )#
2. Usage:
Use this command to enble PoE scheduling to this port.
3. Command Syntax:
poe scheduling enable
4. Example:
The following example enables PoE scheduling to the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if )#poe scheduling enable
switch_a(config-if )#
PoE Schedule:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if )#
2. Usage:
Use this command to set PoE scheduling to this port.