LevelOne IES-1085 - Manual (Page 105)

User Manual Page 105
4. Example:
The following example sets new fixed power limit 15 Watts to the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if )#poe fixed-power-limit 15
switch_a(config-if )#
Power Priority:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if )#
2. Usage:
Use this command to specify the power priority to this port.
3. Command Syntax:
poe power-priority PRIORITY
PRIORITY specifies high, medium, low power priority for this port.
4. Example:
The following example sets high power priority to the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if )#poe power-priority high
switch_a(config-if )#
Power Down Alarm:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if )#
2. Usage:
Use poe power-down-alarm enable command to enable power down alarm to this port.
Use the no poe power-classification enable to disable this function.
3. Command Syntax: