Securitron M380BD - Manual (Page 5)

PN# 500-23300
Page 5 Rev. B, 07/13
J1 (M370) Terminal Block 1 (M370 has a 4-position terminal block)
Position 1 & 2:
Input Power Terminal positions 1 & 2 provide a connection point for
positive (+) and negative (-) 12 and 24 VDC power
connection.
Position 1 = (+) Positive
Position 2 = (-) Negative
Position 3 & 4:
Tamper Indication Terminal positions 3 & 4 of the terminal block provide
connection for tamper sensing. Signal continuity is
disrupted whenever the cover is removed.
J1 (M380) Terminal Block 1 (M380 has an 8-position terminal block)
Position 1 & 2:
Door Position Switch Terminal positions 1 & 2 provide a set of contacts of which
state change is determined by Jumper 4 (JP4) based on
the strike plate’s proximity to the lock face.
Position 3 & 4:
Input Power Terminal positions 3 & 4 provide a connection point for
positive (+) and negative (-) 12 and 24 VDC power
connection.
Position 3 = (+) Positive
Position 4 = (-) Negative
Position 5 & 6:
Tamper Indication Terminal positions 5 & 6 provide connection for tamper
sensing. Signal continuity is disrupted whenever the cover
is removed.
Position 7 & 8:
BondSTAT Terminal positions 7 & 8 provide a set of contacts of which
state change is determined by Jumper 3 (JP3) based on
the strike plate’s magnetic bond to the lock face under
power.
3. Document Configuration Settings
The Board Settings are now complete. Copy your settings onto the adhesive-backed Circuit Board Settings label
enclosed with the mounting hardware packet.
Note: The example shows the
Default settings. Your settings may
vary, based on your checklist.
NO = Normally Open
NC = Normally Closed
Important! Complete the label and affix to the inside cover of your Magnalock
®
This information will be needed if the lock needs to be serviced, replaced or inspected.
M370/M380 Settings www.securitron.com
1-800-624.5625
ON=ENABLED
ON=RED
1-2=NC
1-2=NC
ON=ENABLED
OFF=DISABLED
OFF=GREEN
2-3=NO
2-3=NO
OFF=DISABLED
5 10 20 30
* available on M380BD models only