Securitron M380BD - Manual (Page 4)

PN# 500-23300
Page 4 Rev. B, 07/13
Component Label Component Name Selection Position
SW3
(M370 has a
2-position DIP)
DIP Switch SW3.1:
LED Enable
Position 1 setting of the
DIP switch enables or
disables the display of
the LED for lock status.
ON = LED ENABLED Position 1 ON (default)
OFF = LED DISABLED
(default setting)
Position 1 OFF
SW3 DIP Switch SW3.2:
LED Color Select
Position 2 setting of the
DIP switch controls the
color of the LED
output. Output options
are red or green.
ON = SECURE = RED Position 2 ON
OFF = SECURE = GREEN
(default setting)
Position 2 OFF (default)
SW3
(Auto Relock Timer
available on M380
models only)
DIP Switch SW3.3,
SW3.4 and SW3.5:
Auto Relock Timer
Enable and Delay
Selection
The Auto Relock Delay
Timer is disabled by
default. The delay can
be enabled by setting
the position 3 switch of
SW3 to ON, and then
selecting a time delay
with Position 4 and
Position 5 of SW3.
DISABLE Delay Timer Position 3 OFF (default)
ENABLE Delay Timer Position 3 ON
5 second delay
Position 4 OFF
Position 5 OFF
10 second delay
Position 4 OFF
Position 5 ON
20 second delay
Position 4 ON
Position 5 OFF
30 second delay
Position 4 ON
Position 5 ON
JP3
(available on M380
models only)
Jumper 3:
BondSTAT
Mode Select
A 3-pin jumper that
controls the output
setting for the
BondSTAT in Terminal
Block J1 Position 7 & 8.
(NC) Normally Closed
Circuit Closed when Bond is
secure (default setting)
(NO) Normally Open
Circuit Open when Bond is
secure
JP4
(available on M380
models only)
Jumper 4:
Door Position
Mode Select
A 3-pin jumper that
controls the output
setting for the Door
Position Switch (DPS)
in Terminal Block J1
Position 1 & 2.
(NC) Normally Closed
Circuit Closed when Door is
Closed (default setting)
(NO) Normally Open
Circuit Open when Door is
Closed