Install roll pins into strike plate, Secure strike plate to the door – Securitron M380BD User Manual
Page 10

PN# 500-23300
Page 10
Rev. B, 07/13
4. Install Roll Pins into Strike Plate:
Remove the two (2) roll pins from the hardware packet.
Insert a roll pin into each of the holes in back of strike. Gently tap into place using a hammer
.
5. Secure Strike Plate to the Door
Apply the included thread lock compound to
the 5/16-18 X 1-3/4” flat head socket screw.
Pass the 5/16-18 X 1-3/4” flat head socket screw through the strike bushing, strike plate, two (2)
neoprene washers, door and into the sex bolt as illustrated.
Use a 3/16” hex wrench to tighten the screw into the sex bolt. (While tightening, use a hammer to gently tap
the head of the sex bolt until the head sits flush with the door).
Not Do NOT over-tighten the assembly; the neoprene washers should not be compressed.
Allow the strike to rock on the neoprene washers for proper function and optimum holding force.
Quick Clip 6:
Mounting
Strike Plate
Sex Bolt
Door
(2) Neoprene Washers
Strike Bushing
5/16-18 X 1-3/4”
Flat Head Socket
Strike Plate