Truck bed tailgate, Caution, Warning – Reese 30067 RAIL KIT User Manual
Page 8
30"
2"
3"
19"
4"
13"
**Measure distance for
cutting plastic bed liner.
Prick
mark
Cut bed liner
Cut bed liner
Prick
mark
Figure 19
Truck Bed
Tailgate
12.
Remove 5/8” x 1 1/2“ bolts attaching frame bracket to mounting rails. Move rails rearward or forward to prevent
interference with hole drilling or punching of the truck bed.
CAUTION:
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural
members, etc.
CEQUENT TOWING PRODUCTS
does its best to communicate tow vehicle manufacturer
changes; however, it is ultimately the responsibility of the installer to prevent damage due to installation.
13.
Drill pilot holes in truck bed at prick mark locations. With hole saw or knockout punch create 2 1/2” hole
centered at pilot holes. Note: Consult installer for recommended curing time on spray-in liner before cutting
holes through bed. Optional: Spray under coating around 2 1/2” holes to prevent rusting.
14.
Loosely reattach rails to frame bracket.
15.
From truck bed attach pucks and trim rings to rails (
Figure 20
) using 5/8” button head screw and lock washer.
Tighten to 100ft.lbs. torque.
16.
Insert puck plugs in plugs whenever pucks are not in use. (
Figure 21
)
17.
Install
Signature Series
5th wheel per hitch assembly instructions.
18.
Torque hitch assembly bolts per hitch instructions.
19.
Torque all 5/8” rail kit hex bolts to 170ft.lbs
20.
Replace any brake lines and spare tire that may have been removed/relocated.
WARNING:
DO NOT lubricate threads. It may cause bolt failure.
Figure 20
5/8” BUTTON HEAD
4 PLACES
PUCK
4 PLACES
TRIM RING
4 PLACES
5/8” LOCK WASHER
4 PLACES
Figure 21
Truck Bed
Puck Plug
Puck Assembly
8
30067IN –08DEC05C
PCN8405
©2005 CEQUENT TOWING PRODUCTS, INC.
Litho in USA