Reese 30845 25K ELITE SERIES GOOSENECK - Manual (Page 7)

30845IN – 31OCT12D PCN18116 ©2005, 2012 CEQUENT PERFORMANCE PRODUCTS, INC. Litho in USA 7
For Kits 30845, 40845 & 50845
7. Remove the Signature Series Gooseneck Hitch from the truck bed and prepare for installing the Anchor Tee Pins,
Anchor Handles and the 3/16” linch pins. Install the Anchor Tee Pin by inserting it up through the Anchor bushing
and threading it into the the Anchor Handle. See Figure 13A. Each side of the
Signature Series Gooseneck Hitch gets
one of each anchor handle (Anchor Handle “A” & Anchor Handle “B”). See Figure 13B for correct handle orientation.
The Anchor Tee Pin should be threaded as far as it can go into the Anchor Handle. The hole in the Anchor Tee Pin
will probably not line up with the slot in the Anchor Handle nut at this point and should be turned back slowly until
they are inline. Once aligned, rotate the Anchor Tee Pin 540 degrees (1 ½ times) counter clockwise until the hole
and slot re-
align. See Figures 13C, 13D, 13E. The 3/16” linch pin can now be inserted into the hole.
Fig. 13B
1” Jam Nut
Anchor Handle nut
Hole in Anchor Tee Pin
Anchor Handle
Anchor
Tee Pin
Slot in Anchor Handle nut
The pin will snug up at an undetermined
angle Loosen Tee Pin back to first parallel with
bushing position (less than ½ rotation) Loosen Tee Pin 1 ½ additional
complete rotation for suggested
adjustment.
Fig. 13C Fig. 13D Fig. 13E
Fig. 13A
Anchor Tee Pin
Anchor Bushing
1” Jam Nut
Anchor Handle
Linch Pin
Anchor Handle “B” Shown
Tab Washer
Tab Washer