Gentec-EO PC-Gentec-EO (for MAESTRO and INTEGRA) - Manual (Page 56)

PC-Gentec- EO User’s Manual Revision 5.0 55
Set Energy Mode
This command is used to toggle Energy mode when using a wattmeter.
Text Command Parameters Return
>SSE 1 to turn On, 0 to turn Off
Default: Off
Set Attenuator
This command is used to adjust the processing of the monitor with the readings of the head,
depending on whether the head is using an external attenuator or not.
Text Command Parameters Return
ATT 1 to turn On, 0 to turn Off
The following example sets ATT On, this means that the attenuator in on the detector
Example Response from Monitor
Text Command: *ATT1
Default: Off
Get Attenuator
This command returns the attenuator status. If the attenuator is not available, it will be always off.
Text Command Parameters Return
GAT None 1: On
0: Off
Example Response from Monitor
Command: *GAT Attenuator : 0 \r\n