Gentec-EO PC-Gentec-EO (for MAESTRO and INTEGRA) - Manual (Page 43)

PC-Gentec- EO User’s Manual Revision 5.0 42
8.1.3 Serial Command Directory for Intera and Maestro
Command name Command Description
DISPLAY COMMANDS
Set Range SCS Manually set range.
Set Range Up SSU Change scale to the next higher range.
Set Range Down SSD Change scale to the next lower range.
Get Current Range Index GCR Returns scale index between 0 to 41
Get Autoscale GAS Returns autoscale status
Display Valid Scale DVS Displays the valid ranges for the connected detector head.
Set trigger level STL Set the internal trigger level when measuring pulse energy.
Get Trigger Level GTL Returns trigger level value
Get Mode Display GMD Returns the current display mode on MAESTRO
MEASUREMENT COMMANDS
MEASUREMENT DATA ACQUISITION
Query Current Value CVU Get the value currently displayed on the screen.
Download points CAU Send the values in ASCII to the serial port with the data sampling
setting.
Stop the CAU Command CSU Stop the CAU Command.
Query New Value Ready NVU Determine if new reading is available.
Set the autoscale SAS Set the autoscale.
Get the laser rep rate frequency GRR Send the value in ASCII to the serial port.
Set the joulemeter binary mode SS1 Set the joulemeter binary mode or ASCII mode
Get Binary Joulemeter Mode GBM Returns binary joulemeter mode or ASCII mode
Set Analog Output ANO Enables or disables analog output
MEASUREMENT SETUP
Set Personal Wavelength Correction PWC Specify the wavelength.
Get Wavelength GWL Returns wavelength in nm
MEASUREMENT CONTROL
Set Anticipation ANT Turn anticipation on or off.
Get Anticipation status GAN Returns the anticipation status
Set Zero Offset SOU Zero the reading.
Clear Zero Offset COU Undo the zeroing of the reading.
Get Zero Offset GZO Returns zero offset status
Set diode Zero Offset SDZ Zero the reading for all scale’s for the photodiode.
Set User Multiplier MUL Set the value of the multiplier’s correction value.
Get User Multiplier GUM Returns the current multiplier’s correction value
Set User Offset OFF Set the value of the Offset correction value.
Get User Offset GUO Returns the current offset correction value
SET Single shot Energy mode SSE Set the Energy mode for the calorimeter mode.
Set attenuator ATT Set the attenuator.
Get Attenuator GAT Returns the attenuator status
INSTRUMENT AND DETECTOR INFORMATION COMMANDS
Query version VER Get firmware version of the monitor.
Query Status STS Retrieve detector information and monitor settings.
Query Extended Status ST2 Returns extended status