Fairbanks LoadTronic 3 - Loader Weighing System - Manual (Page 6)

page 6
x To carry out calibration and similar functions when the calibration switch
is set to the enabled position.
x To present measurement results on the LCD display.
x To receive commands from the operator through a keypad and a set of
function keys.
1.3 Calibration Switch
The calibration switch is placed underneath the main unit, refer Figure 1-1.
Calibration is enabled when the switch is in the rightmost position. Ensure
that the switch is in the leftmost position (calibration disabled) during
normal operation of the LOADTRONIC 3.
1.4 Printer (Optional)
The printer is connected to the main unit and positioned as required.
The printer has the following functions:
x Print a load receipt for each truck load.
x Print reports about customer, truck, material, location and load list.
If a printer is connected, you can print a load receipt by pressing the function
key next to the printer symbol (F2). Print/F2 will automatically cancel/zero
the running accumulated total for the current active job.
Figure 1-1 The Calibration Switch is placed underneath the Main Unit.
Fairbanks Scales