Fairbanks LoadTronic 3 - Loader Weighing System - Manual (Page 17)

OPERATOR’S MANUAL page 17
Procedure to start an unspecified job record with a specified target
load:
1. Press 0 on the keypad to open job record no. 0.
2. Press job record/F3 to set the target load (recommended):
- Press Next/F4 repeatedly to highlight the Load-field at the end.
- Type the target load using the keypad, or press the up arrow/
n
to
adjust the load in step of 0.01t. Press and hold the arrow to adjust
the load in step of 0.1t.
3. Press Enter/# to activate the job, or press Cancel/* to abort the
operation. LOADTRONIC 3 returns to automatic weighing mode.
When the job is complete, the operator can press Print/F2 for a customer
receipt (requires a printer), or simply C/F1(no report), refer chapter 4.2 for
more detail about customer reports.
3.3.3 Specified Recording
LOADTRONIC 3 allows the operator to assign job details in the job record:
details about customer, material, truck and/or location. By adding job details
the operator can easily identify a specific job record later. The job details are
printed on the load receipt. The job details of the current job are shown in
the display, refer e.g. Figure 3-5.
Figure 3-4 Setting the target load.