Fairbanks LoadTronic 3 - Loader Weighing System - Manual (Page 19)

OPERATOR’S MANUAL page 19
3.3.4 Selecting a Pre-defined Job Record
If the operator has a set of pre-defined jobs to perform, the assigned job
record including details can be selected from the job record.
Press the job record number directly from the keypad, or open the job list:
1. Press job record/F3.
2. Press the up- and down arrows to set the desired job record number, or
type the number directly on the keypad.
3. Press Enter/# to activate the job, or press Cancel/* to abort the
operation. LOADTRONIC 3 returns to automatic weighing mode.
When the job is complete, the operator can press Print/F2 for a customer
receipt (requires a printer), or C/F1 (no report), refer chapter 4.2 for more
detail about customer reports.
3.3.5 Multiple Jobs
LOADTRONIC 3 can manage multiple active jobs. The operator can
maintain multiple active jobs by selecting a new job record without clearing
the current record; the operator can switch between different jobs in the
same time period. All active jobs will be handled individually regarding
running total, number of buckets and the remaining weight to be loaded.
The number of active jobs is shown in the lower right corner of the display.
The operator can keep up to 9 active jobs at a time; the maximum number of
allowed active jobs can be set in Parameter Setup II, refer Figure 3-6 and
LOADTRONIC 3 Installation Guide.