Fairbanks LoadTronic 3 - Loader Weighing System - Manual (Page 46)

page 46
System Information holds information about e.g. software versions and legal
system files.
5.1 Load List, Event List and Error List
There are 4 lists available: Loadlist, Event list, Error list and a Combined list
of these three lists. Press Next/F4 to toggle between the lists. Press
š/F2 and
›/F3 to page up and -down in the list. Press the up- and down arrows to
move up and down a single entry. Errors/failures are listed in a red font. For
backup of the logfiles, refer chapter 5.2.
The Loadlist is a list of each recording, holding information about the total
load, number of buckets delivered, and date/time of the recording, refer
Figure 5-2. Loadlist is a compressed list of the information given in the
customer report, refer chapter 4.2.2.
LOADTRONIC 3 gives a warning in the top line at system start up when the
Loadlist is more than 95% full, refer chapter 3.13 and chapter 4.2.
The Event list holds information about every event performed by the system:
calibration, backup, changing of legal system parameters etc.
Figure 5-2 Loadlist.
Fairbanks Scales