beautypg.com

Fairbanks LoadTronic 3 - Loader Weighing System User Manual

Page 49

background image

OPERATOR’S MANUAL

page 49

5.3 Copy Calibration Details

The attachment descriptions are stored in ID number 1 to 10; calibration
details are stored in corresponding A1 to A10. Calibration details stored in
e.g. A1 can be copied to e.g. A2 for backup, refer Figure 5-6.

Procedure for copying attachment:

1. Open Main Menu – Service – Copy Attachment, refer chapter 2.1.
2. Use the up- and down arrows to select the desired attachment ID from

which calibration details are copied from.

3. Press Next/F4 to toggle between the attachment source and destination
4. Use the up- and down arrows to select the desired attachment ID to

which calibration details are copied to.

5. Press Enter/# to copy. The calibration switch must be enabled, refer

Figure 1-1.

Figure 5-5 Restore.