Fairbanks LoadTronic 3 - Loader Weighing System - Manual (Page 21)

OPERATOR’S MANUAL page 21
3.5 Changing and Deleting Attachment
10 different attachments can be used with LOADTRONIC 3. The current
attachments ID number (1-10) is shown in the upper right corner of the
display, refer Figure 3-7.
The attachments that are listed in blue color have been calibrated on the
wheel loader and are available, refer LOADTRONIC 3 Installation Guide.
Attachments that are not calibrated on the wheel loader are listed in red
color; you can not select the attachment before it has been calibrated.
Taring and basic calibration must be performed for every attachment to be
used with LOADTRONIC 3, refer LOADTRONIC 3 Installation Guide.
Procedure for changing attachment:
1. Fit the attachment to the machine.
2. Open Main Menu - Change Attachment, refer chapter 2.1.
3. Press the arrows to highlight the attachment identification number and
description. Press Select/# to select the correct attachment (or press
Cancel/* to return to automatic weighing mode without changing the
setting).
4. Ensure that the attachment is empty.
LOADTRONIC 3 requires a zeropoint adjustment, refer chapter 3.6.
Figure 3-7 Changing Attachment.