Fairbanks 2000 SERIES Rocker Column Railroad Scale - Manual (Page 24)

03/10 24 50614 Rev. 5
Side View
1 1/2" Min
Front View
Load
cell Load
cell
Upper Receiver Plate & Bearing
Lower Receiver Plate w Bearing
3/4-10 X 3" Hex Bolt
Clamp Plate
3/4-10 X 3 1/2" Hex Bolt
50614_24
11: Beginning with an end Section, position a suitable capacity jack to raise and lower the
module corner as needed. Install and tighten the upper receiver plate to its final torque value.
Grease and install the upper bearing, the lower receiver plate, clamp plates, and bolts, leav-
ing the bolts loose. Install the loadcell by inserting the top of the load cell in the upper cup,
then slowly lowering the module and guiding the bottom of the load cell into the lower cup.
Reset the blocking so the loadcell supports the corner, but do not remove the blocking at
this time.
Side View
1 1/2" Min
Front View
Load
cell Load
cell
Tighten Upper Bolts
Shift Clamp Plate
to Plumb & Level
the Loadcells
50614_25