Teledyne 6700-C Total Organic Carbon Analyzer (Hi-Temp Combustion version) - Manual (Page 29)

High Temperature Combustion Operation
Teledyne Analytical Instruments 29
Operation
After proper installation the instrument must be calibrated.
Following calibration, the instrument is ready to be placed “ON-LINE”.
Note: For any non–standard or specific operational procedures,
please refer to the “INSTALLATION” and any addenda
that accompanies this manual for details on your specific
application. Items such as valving, stream sequencing,
automatic calibration, etc. are non-standard items and will
be described in an attached addendum.
4.1 Menus
The advanced design of the Model 6700C Analyzer eliminates
complicated, routine, and sometimes confusing Menus. The operator/
software interface is as simple as the analyzer’s construction, operation,
and most importantly, maintenance.
The analyzer has no manual adjustments. Complete calibration and
operation are computer controlled by the operator, following menu
prompting and selection of the operation of choice.
The following menu and operation descriptions are intended to
guide the Operator through all the functions of the Model 6700C TOC
High Temperature Combustion Analyzer.
After primary power (110/220VAC) has been applied to the
Analyzer and self-diagnostic procedure has been completed, the system
automatically boots up to the following Run Screen. If not, turn main
power OFF, then ON to reboot.
4.2 Run Mode
Run is the normal analysis mode. The display indicates the current
TOC or both TOC and TN (optional) values, [IR] IR response, and
[Flow] carrier gas flow rate.