Alliance Laundry Systems UF35PV - Manual (Page 58)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming
F232059 56
Preprogrammed Cycles
This section lists the 39 preprogrammed (ready-to-use)
cycles. To run a cycle, first make certain that the
computer is in the Run Mode. Then enter the two-digit
code for the desired cycle, and press the Start key.
Test Cycle 01 (standard listing) is the first of the
39 preprogrammed cycles. This cycle is used to verify
proper operation of the machine.
Any of these 39 cycles may be erased and replaced by
new cycles. As shown earlier in this section of the
manual, the cycles may also be edited and revised to
match a particular application’s specific needs. Thirty-
seven of the preprogrammed cycles use high speed
spin No. 3 (maximum G force) for the final extract.
The following prompts are set at the factory:
● Degrees F
● One drain
● Advance enabled
● Manual Mode enabled
● Wet clean disabled
● Balance system setting
Cycle Categories
01 Test
Hotels and Motels
02 Sheets, light soil, cotton/poly blends
03 Sheets, light soil, no bleach, cotton/poly blends
04 Towels, light soil, cotton
05 Towels, light soil, no bleach, cotton
06 Sheets, medium soil, cotton/poly blends
07 Towels, medium soil, cotton
08 Blankets, spreads, no bleach
09 Blankets, spreads, cold water
10 Towels, heavy soil, cotton
11 Rinse and spin only
Healthcare
12 Sheets, light soil, cotton/poly blends
13 Towels, light soil, cotton
14 Sheets, heavy soil, cotton/poly blends
15 Towels, heavy soil, cotton
16 Thermal blankets, bleach, cotton
17 Diapers, pads, heavy soil, cotton
18 Personals, bleach
19 Personals, no bleach
20 Pads, polyester