Alliance Laundry Systems UF35PV - Manual (Page 49)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming
47 F232059
Programming Heat
1. To program auxiliary heat (either electric or
steam), the computer must be in the Program
Mode, and the cycle programming sequence must
be ready for the next step.
NOTE: Models with both electric and steam heat
are equipped with a selector switch which allows
the user to select either option. Because both
options are energized by the WE-6 microcomputer
via the same output, the procedure for
programming a heat step will be the same for
either. The switch directs the output signal only to
the selected option.
2. The machine must be filled with water.
3. Press the Heat key. The display will read
“HTnncc”.
4. Press the Enter key. The display will read either
“080Fnn” or “025Cnn”, depending on whether
Fahrenheit or Centigrade is prompted.
5. Enter the final temperature desired. Three digits
must be entered for the temperature. If the
desired temperature is less than 100 degrees, the
first digit should be 0. The valid temperature
range is 80-200 degrees Fahrenheit and
25-93 degrees Centigrade. The computer will not
accept temperatures outside of this range. If 100
degrees Fahrenheit is selected, the display will
read “100Fcc”.
6. Press the Enter key. The display will read
“H---M”. Now assign the maximum time in
hours and minutes for the water to reach the
desired temperature.
7. Press the Enter key and go to the next step in the
cycle.
Programming a Wash Step
1. The computer must be in the Program Mode, and
the cycle programming sequence must be ready
for the next step.
2. Press the Wash key. The display will read
“W-nncc”.
3. Now press the number key (from 1 to 7) that
corresponds to the desired wash step listed in
Table 9.
Table 9
Wash Description
1 18 seconds forward, pause 3 seconds;
18 seconds reverse, pause 3 seconds; repeat
2 3 seconds forward, pause 27 seconds;
3 seconds reverse, pause 27 seconds; repeat
3 No agitation
4 10 seconds forward, pause 20 seconds;
10 seconds reverse, pause 20 seconds; repeat
5 Refer to Programming a Wash 5 Thermal
Cool-Down. Agitation is the same as Wash 1,
or most recent agitation
6 4 seconds forward, pause 56 seconds;
4 seconds reverse, pause 56 seconds; repeat
7 No agitation, drain open (no automatic
refilling)
NOTE: A Wash 7 step can be programmed when
a drain without rotation is desired. However, a
spin step must not follow Wash 7 since
balancing is done only in Drain 1, A, or B.
NOTE: In all wash steps except Wash 7, the
machine will automatically refill to the most
recent water level (if any), and the drain will be
closed.