Alliance Laundry Systems UF35PV - Manual (Page 15)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Operation
13 F232059
Wet Clean Capabilities
Differences in WE-6 prompt (setup) options
The WE-6 software provides the usual setup options:
● Degrees F or C
● One or Two drain
● Advance or No Advance
● Manual or No Manual
● Balance setting
In addition, the software provides a new selection: Wet
Clean/No Wet Clean. The wet clean/no wet clean
option enables or disables wet clean functions. In
summary then, the prompt (setup) options are now as
follows:
● CEN/FAR
● 1DRAIN/2DRAIN
● ADV/NO ADV
● MANUAL/NO MAN
● WET CL/NO WCL
● BAL SW, BAL 1, BAL 2, BAL 3
Wet Clean Functions
Wet clean functions include a reduced wash speed
capability and a recirculation pump capability. These
functions are enabled by the WET CL/NO WCL
prompt selection. Other wet clean features are
permanently enabled, and can be used for other
applications as well. In particular, extra supply
capability (up to eight supplies, in two banks of four
supplies), and additional agitation actions as outlined
below.
Agitations:
● Wash 1 – normal: 18 seconds forward / three
seconds off / 18 seconds reverse / three seconds
off; repeat
● Wash 2 – gentle: three seconds forward /
27 seconds off / three seconds reverse / 27
seconds off; repeat
● Wash 3 – no rotation
● Wash 4 – ten seconds forward / 20 seconds off /
ten seconds reverse / 20 seconds off; repeat
● Wash 5 – uses most recent agitation; defaults to
Wash 1 agitation
● Wash 6 – super gentle: four seconds forward /
56 seconds off / four seconds reverse / 56 seconds
off; repeat
● Wash 7 – no rotation; drain 1 (sewer drain) open;
no attempt to refill to level