Cycle programming – Alliance Laundry Systems UF35PV User Manual

Page 41

Programming

F232059

Cycle Programming

Displaying a Cycle in Memory

1. Locate the key-operated programming switch

behind the access door directly below the
emergency stop button (top right on the front
panel of the washer-extractor).

Insert the key and turn the switch to the
PROGRAM position. The display will read
“CYC00”.

2. Press the Edit Cycle key on the keypad. The

display will read “DCYC00”.

3. Press the two-digit code to display the desired

cycle number: For example, press key 2 and then
key 5 to select cycle 25. The display will read
“DCYC25”.

4. Press the Enter key. The computer will search for

cycle information for this cycle number.

If no cycle information exists, the computer will
flash “NCYC25” followed by “ADD?”. To add
this cycle, press the Enter key and proceed to the
Add Cycle programming mode. If adding this
cycle is not desired, press the Clear key, and the
computer will then return to the normal
programming mode.

5. If cycle information does exist for cycle 25, the

computer will display “0425”, for example, to
indicate that cycle 25 has been run four times. To
clear the count (reset it to zero), press key 0. The
display will then show “0025”.

If clearing the count is not necessary or if it has
just been cleared, press the Enter key. The
computer will now display “HH0125”, indicating
the first step of cycle 25.

6. Press the Advance key to move to the next step of

the cycle. To access further information
pertaining to each step (for example, temperature
and/or time), press the Enter key. If the display
shows a temperature, press the Enter key again to
display the time. Press the Enter key once more
to advance to the next step.

7. At the end of the cycle, the computer will display

“END-25” for two seconds and return to the
normal programming mode.

8. Return the Program Mode switch to the RUN

position and remove the key.

NOTE: Never press the Clear key while displaying
a cycle in memory except to edit or delete a step.

Displaying Individual Cycle Usage