Alliance Laundry Systems UF35PV - Manual (Page 43)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming
41 F232059
13. To delete a step within a cycle, press the Clear
key while the computer is displaying the step to
be deleted. Press the Clear key again: the display
will read “WAIT” while it is deleting the step.
The computer will then display the next step in
the cycle, using the same step number as the
deleted step.
14. If the Add Cycle key is pressed by mistake
instead of the Edit Cycle key when the cycle
number to be edited is entered, the display will
flash “EXISTS” and “EDIT?”. To recover, press
the Enter key, and the computer will change to
the Edit Mode.
Erasing a Cycle in Memory
1. Locate the key-operated programming switch
behind the access door directly below the
emergency stop button (top right on the front
panel of the washer-extractor).
Insert the key and turn the switch to the
PROGRAM position. The display will read
“CYC00”.
2. Press the Erase Cycle key. The display will read
“ECYC00”.
3. Press the two-digit code for the cycle number that
is to be erased. If key 2 and key 5 are pressed, the
display will read “ECYC25” if cycle 25 is
chosen.
4. Press the Enter key. The display will read
“WAIT” while it is erasing the cycle. The display
will then return to “CYC00”. If there is no such
cycle number in memory, the display will read
“NCYC25”. To not erase a cycle, press the Clear
key before pressing the Enter key. The display
will return to “CYC”.
5. Return the Program Mode switch to the RUN
position and remove the key.
Programming a Wet Clean Cycle
None of the standard 39 preprogrammed cycles
includes wet clean steps. A sample wet clean cycle is
included following the 39 standard cycle charts near
the end of this manual. Review of this sample cycle
will provide some understanding of the wet cleaning
process. The sample cycle is provided as a model wet
clean cycle and is not intended as a recommendation.
However, no wet clean cycle should be programmed
until a wet clean chemical manufacturer is consulted.
NOTE: Use of any wet clean cycle prior to approval
by a wet clean chemical manufacturer’s
representative can result in damage to garments.