Alliance Laundry Systems UF35PV - Manual (Page 51)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming
49 F232059
4. When the desired cool-down temperature is
displayed, press the Enter key. The display will
show “H---M”. Now enter the maximum time in
hours and minutes for the computer to reach the
target cool-down temperature.
Experimentation may be necessary to determine
the exact time required with each installation to
enable the computer to reach the target cool-
down temperature. Use the edit feature to revise
the Wash 5 step during the experimentation
process.
When the computer performs the Wash 5 step,
the temperature in the sump must be greater than
the target cool-down temperature. Otherwise, the
computer will advance past the Wash 5 step.
5. When the desired time is displayed, press the
Enter key and go to the next step in the cycle.
Programming No Reversing
All agitation is programmed by first pressing the Wash
key and then pressing either key 1, 2, 3, 4, 5, 6, or 7 for
the type of agitation desired during the wash step.
If no reversing is desired (rotation continuous in one
direction), use the following procedure:
a. Press the Wash key.
b. Then press either key 1 or key 2.
c. Then press the No Reverse key.
d. Then press the Enter key.
The display will show either “W1nncc” or “W2nncc”,
depending on the kind of agitation selected. The
display will not indicate that the no-reverse option was
selected, but the machine will obey the instructions.
The no-reverse option is normally used with Wash 1
steps but may be used with other appropriate
functions. The no-reverse option may be programmed
in wash, supply, heat, and overflow steps. The No
Reverse key must be pressed just prior to pressing the
Enter key when programming a step. Refer to step 4
under Programming a Wash Step.
Programming a Soak Step
1. The computer must be in the Program Mode, and
the cycle programming sequence must be ready
for the next step. (The previous step should have
been a fill and/or supply step.)
2. Press the Soak key. The display will read
“SKnncc”.
With machines equipped with auxiliary heat
(optional steam or electric), it is possible to
program a soak-with-temperature step. During
such a step, the machine will soak for the time
programmed at the temperature programmed and
will maintain that temperature throughout the
step.
To program a soak with temperature step use the
following procedure:
a. Press the Heat key after pressing the Soak key.
The display will read either “080Fcc” or
“025Ccc”, depending on whether Fahrenheit
or Centigrade is prompted.
b. Enter the temperature desired for the machine
to maintain during the soak step. Three digits
must be entered for the temperature. If the
desired temperature is less than 100 degrees,
the first digit should be 0. The valid
temperature range is 80-200 degrees
Fahrenheit and 25-93 degrees Centigrade. The
computer will not accept temperatures outside
of this range. If 100 degrees Fahrenheit is
selected, the display will read “100Fcc”.
3. Press the Enter key. The display will read
“H---M”. Now assign the soak step the desired
time in hours and minutes. During the soak step,
no agitation will occur. The WE-6
microcomputer will maintain the water level
during the soak cycle at whatever previous level
was programmed.
4. Press the Enter key and go to the next step in the
cycle.