Alliance Laundry Systems UF35PV - Manual (Page 23)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Operation
21 F232059
Supply Dispenser
Dry supplies are placed in the supply dispenser
compartment cups prior to the start of each cycle.
Liquid supplies can be injected directly into the supply
dispenser by an external chemical supply system.
Supply dispenser compartment cups must not be
removed when an external chemical injection supply
system is attached to the washer-extractor.
Cycle Selection
NOTE: Press keys at their centers just hard enough
to activate them.
Find the cycle number of the desired wash cycle from
the Standard Cycle Charts in the Programming
section of this manual. Cycle numbers must be two-
digit numbers from 01 to 39.
Press the numbers desired on the keyboard and note
that these numbers are displayed after “NEXT”.
When keys are pressed on the keyboard, a beep will be
heard. If an error is made, press the numbers again. As
numbers are entered, they move from right to left on
the display.
NOTE: If the washer-extractor is equipped with
both steam and electric heat, the selector switch on
the valve panel must be in the correct position for
the desired heat source, down for steam heat, up for
electric heat.
Cycle Execution
To start the selected cycle, press the Start key. If the
selected cycle number is not in the computer memory,
the display will show “NCYC”. If this happens, select
another cycle. Otherwise, the display will now show
the first step. For example, if the display reads
“HL01”, “HL” represents a hot fill to low level, and
“01” indicates that this is the first step of the cycle.
As the cycle proceeds, the display will show the
function being executed, the step number, and the
cycle number selected. Pressing the Edit Cycle key
while the cycle is running will cause the display to
show the remaining cycle time in minutes. Pressing
this key again will return the display to normal.
To begin the cycle at any step other than the first step,
press the Advance key to advance through the cycle to
the desired starting point. (The Advance key is enabled
at the factory and can be disabled at the laundry site.)
Then press the Start key.
It is possible to skip to the next step in a cycle, with the
exception of a drain step; drain steps must be allowed
time to complete.
When the display shows the step desired to begin the
cycle, press the Start key.
If the door is not locked, the display will indicate
“CLOSE” and “DOOR”. If this occurs, be sure the
door is closed and locked and press the Start key again.
If the LED indicator lights for the computer outputs
indicate that one or more outputs are activated but the
washer-extractor is not functioning according to the
output or outputs indicated, contact a service
technician.
As water fills the washer-extractor, one or more of the
indicator lights located to the left of the keyboard will
come on and stay on until the required water level is
reached. LED dots located in the upper left corner of
the last three digits on the right of the display will
illuminate to indicate the water level(s) reached:
● When the indicator dot in the last digit on the
right is lit, the low water level has been reached.
● When the dot in the next-to-the-last digit is lit,
medium water level (optional) has been reached.
● When the dot over the third digit from the right
has been lit, high level has been reached.
The cycle will continue until its completion. Then the
display will show “DONE”.