Alliance Laundry Systems UF35PV - Manual (Page 36)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming
F232059 34
NOTE: The manufacturer does not recommend
more than one minute for a drain step. If the
machine does not drain in the amount of time
programmed, the “EMTY” alarm will be
displayed.
12. Press the Enter key. The display will now read
“0539”, indicating that the computer is ready for
step 5.
13. A natural next step in the cycle might be a
dilution rinse.
a. Press the Cold and High keys to program a
cold fill to high level. The display will read
“CH0539”.
b. Press the Enter key. The display will read
“M---S”.
c. Enter the desired time for the computer to
allow the machine to fill to high level. Five
minutes is acceptable. Press key 5. The
display will read “5M-00S”.
NOTE: If the machine does not fill in the amount of
time programmed, the “FILL” alarm will be
displayed.
14. Press the Enter key. The display will read
“0639”, indicating that the computer is ready for
step 6.
15. Next, program another wash step:
a. Press the Wash key and key 1 to program an
action with normal reversing. The display will
read “W10639”.
b. Press the Enter key. The display will read
“M---S”.
c. Now enter the step duration. Three minutes is
acceptable. Press key 3. The display will read
“3M-00S”.
16. Press the Enter key. The display will read
“0739”, indicating that the computer is ready for
step 7.
17. Now program a drain step:
a. Press the Drain key. The display will read
“D-0739”. Then press key 1. The display will
read “D10739”.
b. Press the Enter key. The display will now read
“M---S”.
c. Enter the length of time the computer will
allow the machine to drain (one minute).
Press key 1. The display will read “1M-00S”,
indicating that a one-minute step has been
programmed.
18. Press the Enter key. The display will read
“0839”.
19. Program a cold fill to high level:
a. Press the Cold key and the High key. The
display will read “CH0839”.
b. Press the Enter key. The display will read
“M---S”.
c. Enter the maximum time to allow for the fill.
In this case, five minutes is sufficient. Press
key 5. The display will read “5M-00S”.
20. Press the Enter key as always after programming
a time duration. The display will read “0939”,
indicating that the computer is ready for step 9.
21. For step 9, program the agitation action for
another dilution rinse.
a. Press the Wash key and key 1 to program an
action with normal reversing. The display will
read “W10939”.
b. Press the Enter key. The display will read
“M---S”.
c. Enter the time for the dilution rinse (three
minutes).
Press key 3. The display will read “3M-00S”.
22. Press the Enter key. The display will read
“1039”, indicating that the computer is ready for
step 10.
23. The dilution rinse water must be drained once
again.
a. Press the Drain key. The display will read
“D-1039”. Then press key 1. The display will
read “D10739”.
b. Press the Enter key. The display will read
“M---S”.
c. Enter the length of time the computer will
allow the machine to drain (one minute).
Press key 1. The display will read “1M-00S”,
indicating that a one-minute step has been
programmed.
24. Press the Enter key to move to step 11 of the
cycle. The display will read “1139”.