Alliance Laundry Systems UF35PV - Manual (Page 25)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Operation
23 F232059
Stop Routine
The operator can select the agitation which will be in
effect for the entire Stop routine. This will help
prevent tangling of the load and provide maximum
control. Three agitations are available for the Stop
routine. They are as follows:
Wash 1
● 18 seconds forward
● 3 seconds pause
● 18 seconds reverse
● 3 seconds pause
● sequence repeated
Wash 2
● 3 seconds forward
● 27 seconds pause
● 3 seconds reverse
● 27 seconds pause
● sequence repeated
Wash 3
● no agitation
NOTE: The forward and reverse times differ
slightly for the Wash 1 selection. These times give
the best results during the Stop routine when no
water is in the washer-extractor.
To select the agitation in the Stop routine, program a
Wash 1, 2, or 3 step for 1 second. The washer-
extractor will begin refilling to the most recent water
level if the time is more than 1 second. If the most
recent wash type was Wash 4, 6, or 7, the WE-6 will
default to no agitation (Wash 3) during the Stop
routine.
NOTE: If the desired action is not programmed in
the final cycle step, the computer will default to the
most recent action in the cycle. If the cycle stops
prematurely, the most recent action at the time the
cycle is interrupted will be in effect during the Stop
routine.
The display will read “W1-cc”, “W2-cc”, or “W3-cc”
for Wash 1, Wash 2, or Wash 3 action during the entire
Stop routine until the final 10 seconds. (The “cc” here
stands for the current cycle number and will be
represented by numbers in the actual display.) During
the final ten seconds, the display reads “STOPcc”. The
display will then read “DONEcc”. At that point, the
door can be opened.
NEVER insert hands or objects into
basket until it has completely stopped.
Doing so could result in serious injury.
SW012
WARNING