Mityvac MV8500 silverline elite aUtoMotive test kit - Manual (Page 20)

Page Number - 0 Form 8433
automatic fLuiD refiLL Kit
Included in the pump kit are components designed
to automatically maintain a constant level of new
fluid in the master cylinder or hydraulic clutch
reservoir while vacuum bleeding . The components
include two cap adapters that fit most pint and
quart brake fluid bottles (1-1/4” side mouth), and
three master cylinder/reservoir refill plates .
SERVICE PROCEDURES
1) Evacuate as much old fluid as possible from the
master cylinder or clutch reservoir .
) Replace the lid on a pint or quart size bottle of
new brake fluid with the appropriate cap adapter .
3) Select the appropriate refill plate and place it on
top of the master cylinder or clutch reservoir .
4) Invert the bottle of fluid with the feeder adapter
attached, and insert the feeder adapter into the
hole in the master cylinder plate . Push down on the
bottle until the feeder adapter snaps into the refill
plate .
5) Bleed the hydraulic brake or clutch system .
NOTE: Take care when inserting and removing the
brake fluid bottle to avoid spillage .
FIGURE 17: AUTOMATIC FLUID REFILL KIT