Luminex IS Version 2.3 - Manual (Page 111)

x
MAP Technology
PN 89-00002-00-110 Rev. B 101
Statistics Column
Definitions
The blocks of statistical data are displayed such that the first row of
data represents the column headers and the following rows represent
the samples that were acquired for the batch.
%CV (Optional) The measure of relative dispersion within the distribution.
%CV = 100 x Std Dev / Mean
Peak (Optional) The value that is equal to the largest number of data points within
the distribution. For example in data set {1,2,2,3,3,3,4,5}, 3 is the peak
because it occurs the most number of times in the distribution list.
Std Dev (Optional) The measure of dispersion within the distribution.
Std Dev = ( ( N
Σx
i
2 -
Σx
i
)2 / N (N-1) ) 1/2
Trimmed Count (Optional) The number of data points in the trimmed distribution (N
t
).
Trimmed Mean (Optional) The sum of the data points in the trimmed distribution divided by
the number of data points.
Trimmed Mean =
Σx
i
/ N
t
Trimmed %CV (Optional) The measure of relative dispersion within the trimmed distribution.
Trimmed %CV = 100 x Trimmed Std Dev / Trimmed Mean
Trimmed Peak (Optional) The value that is equal to the largest number of data points within
the trimmed distribution.
Trimmed Std
Dev (Optional) The measure of dispersion within the trimmed distribution.
Trimmed Std Dev = ( (N
t
Σx
i
2
-
Σx
i
)
2
) / N
t
(N
t
-1) )
1/2
Avg Result (Optional) The average of any replicate samples' final test results
based on a qualitative or quantitative analysis.
Table D-2 Statistics Definitions
Statistic Description
Table D-3 Statistic Column Definitions
Column Name Description
Location The location of the sample in terms of the command list sequence (1,
2, 3,...), the well placement (A1, B1, C1, ...) or both (1(A1), 2(B1),
3(C1), ...)
Sample The name of the sample as defined in the batch setup. Limited to 30
characters.
Test1, Test2, … , TestN The number of test columns following the Sample column will depend
on the number of tests defined in the Template used to create the
batch. Each of the test columns will contain the test name for any
given test. Therefore if the Template has 3 tests named Protein A,
Protein B and Protein C, then these names will appear in the 3 test
column headers in the Output.CSV file. Limited to 30 characters.