Luminex FLEXMAP 3D Hardware User Manual - Manual (Page 31)

Uninterruptible Power Supply (UPS) or Surge Protector
Luminex recommends using either an uninterruptible power supply (UPS) or a surge
protector to protect your system from power outages. Use a UPS that provides 1300 watts for
at least 45 minutes. Select a surge protector that fits your requirements with regard to
electrical environment, endurance, suppressed voltage rating, and method of protection. The
surge protector requires three outlets and a minimum rating of 1500 watts. Either piece of
equipment should be listed by Underwriters Laboratory (UL) or a similar listing body, certified
by Canadian Standards Association (CSA), and marked Conformité Europeénne (CE) for
nondomestic use.
Printer
Use a printer compatible with Microsoft ® Windows XP SP3.
Barcode Labels
Use Code 128 barcode label type when scanning barcode labels into the system.
Vortex
Use VWR product number 58816-12, with a speed range of 0 to 3200 rpm, or equivalent.
Bath Sonicator
Use Cole-Parmer ® product number 08849-00, with an operating frequency of 55 kHz, or
equivalent.
Specifications
The Luminex ® FLEXMAP 3D ® system is designed to fit a series of standards for speed,
accuracy, sensitivity, and capacity. The following topics provide the specifications for the
Luminex FLEXMAP 3D system.
CAUTION: Read and observe specifications carefully.
General
Indoor use only
Physical dimensions: 58.4 cm (23 inches) W x 65.3 cm (25.7 inches deep, including the required 1.25
inches for proper cooling) D x 54.7 cm (18.0 inches) H. Additional space required for the arm, monitor,
keyboard, mouse and optional barcode scanner does not exceed 64.8 cm (25.5 inches) W by 61 cm
(24.0 inches) D.
Weight: up to 91 kg (200 lbs), including the instrument, monitor arm, monitor and accessories such as
the keyboard, mouse, and barcode scanner.
Installation Category II
FLEXMAP 3D ® Hardware User Manual
20