Luminex FLEXMAP 3D Hardware User Manual - Manual (Page 14)

Testing and Certification
The FLEXMAP 3D system has been tested by MET.
FIGURE 1. MET Mark
In addition, Luminex FLEXMAP 3D complies with European Union (EU) safety requirements
and therefore may be marketed in the Europe Single Market. The following European Union
compliance label appears on the back of the FLEXMAP 3D instrument.
FIGURE 2. European Union Compliance Label
Safety Precautions
Read the following safety information before using the FLEXMAP 3D instrument. This
instrument contains electrical, mechanical, and laser components that, if handled improperly,
are potentially harmful. In addition, biological hazards may be present during system
operation. Therefore, Luminex recommends that all system users become familiar with the
specific safety advisories below in addition to adhering to standard laboratory safety
practices.
In any situation in which you encounter this symbol, consult this manual or other Luminex
documentation to determine the nature of the potential hazard and any necessary actions
you must take.
CAUTION: The protection provided by the equipment can be impaired or the
warranty voided if the Luminex FLEXMAP 3D system is used in
a manner not specified by the instructions or by Luminex
Corporation.
Safety
3