Magnum Venus Plastech ADVANTAGE - Manual (Page 47)

Advantage Gelcoater
Remove the resin wand from the resin and allow the wand to drain into an
appropriate container.
Lock gun open. Slowly bring pressure up on resin pump. Slowly pump
extra resin from system. Release gun trigger.
Place an appropriate container under the gun head.
Lock the gun trigger back.
Place wand in container of flush.
Turn the PUMP PRESSURE regulator knob clockwise until the pump
begins to stroke (even, slow strokes).
When clean solvent flows from the gun head, close the PUMP
PRESSURE regulator knob by turning it counterclockwise until the PUMP
PRESSURE gauge reads “0”.
Make sure air charge is relieved from the accumulator by inserting a
1/16” rod into charging valve on top of the resin accumulator.
DANGER DANGER DANGER DANGER DANGER
Slowly begin to unscrew and remove the resin accumulator.
Clean the resin accumulator with solvent.
Place a container under the resin filter and slowly unscrew the filter tank
from the filter body (see Figure 38).
WARNING
Never unscrew the resin accumulator while it is still
charged. You may be seriously injured.
NOTE
STOP! If accumulator is hard to unscrew by hand, accu-
mulator may still be charged. Gently push a rod up into
the resin filter body and gently push up on the poly ball.
This relieves the charge from the accumulator. Once the
charge is relieved, unscrew the accumulator.
43