Advantage gelcoater shutdown – Magnum Venus Plastech ADVANTAGE User Manual

Page 38

Text mode
Original mode

Advantage Gelcoater

ADVANTAGE Gelcoater
Shutdown

Chapter

Short-Term Shutdown

Drain Moisture Filter

Drain moisture filter by holding a small, empty container under the filter
and turning the filter valve beneath the filter until water drains out (See
Figure 32).

NOTE

Cleaning the gun head is required if you are stopping
production or there will be long pauses in operations
for lunch, part cure or any reason.

CAUTION

Always wear approved eye protection when working
near pressurized equipment.

NOTE

This section discusses short-term shutdown. Follow
these procedures whenever the gun will be idle for at
least the standard gel time of your materials. If the gun
will be idle for longer than one week, perform Long-Term
Shutdown.