Magnum Venus Plastech ADVANTAGE - Manual (Page 40)

Advantage Gelcoater
Soak the nozzle assembly parts in a closed container of solvent.
Visually inspect the open ports of the gun block for signs of gelled mate-
rial after flushing.
Remove Fluid Pressure
Follow all warnings and suggestions regarding the use of respirator,
clothing, and appropriate safety procedures recommended by manufac-
turers of your material.
Turn PUMP PRESSURE regulator knob counterclockwise until the pres-
sure gauge reads “0”.
Position gun-head over suitable container and pull gun trigger and lock
open to drain fluid pressure from system.
Flush the gun into an appropriate container.
Relieve charge from accumulator by inserting a 1/16” rod into charging
valve on top of resin accumulator. (See figure 33)
WARNING
Solvents such as acetone are extremely flammable.
WARNING
Draining the air charge from accumulators MUST NOT be
done unless resin fluid pressure is relieved from pump-
ing system.
36
NOTE
When using solvent for cleaning or flushing, be sure to
store the used solvent in a manufacturer-approved con-
tainer with a tight-fitting lid for storage while waiting to
run the used solvent through your recycling equipment.
Solvents evaporate quickly.