Magnum Venus Plastech ADVANTAGE - Manual (Page 17)

Advantage Gelcoater 13
CAUTION
After filling the catalyst jug, reinstall cap on jug. Other-
wise, catalyst may be contaminated.
Figure 9: Fill Catalyst Jug
Place the gelcoat resin container in position on or near the Advantage
Gelcoater. You need at least 2 gallons (7.5 liters) of gelcoat resin to
begin operations.
Be sure you have enough solvent to fill the flush tank at least half full (at
least 1-1/2 gallons). Do not fill the flush tank yet; this procedure is de-
scribed later in this manual.
Check Hoses
Check hoses for abrasions, kinks, and cuts.
CAUTION
If the gelcoat resin runs out during operation, the pump
will runaway and damage may occur.
NOTE
Runaway/The speed of the pump increases immedi-
ately and damage to the pumping system can occur.